Here is the result of my first two part Mold, The terminator helm is 100% Greenstuff and for my own use only. On a side note, I would appreciate any tips on making Green stuff stronger.
Edits from Comments.
I used a two part mold made from insta mold. I had to make the bottom mold first then do the top. I also designed my mold halves to fit in a pair of 25mm bases. Doing that let me press the two halves in a vice to press out extra green stuff and allow it to cure. This leaves some hellish flash but that was easily cut away with a knife and steady hand.
And WarFog was kind enough to post his guide on casting with Procreate which can be found Here @ Warfog's Blog.
I used a two part mold made from insta mold. I had to make the bottom mold first then do the top. I also designed my mold halves to fit in a pair of 25mm bases. Doing that let me press the two halves in a vice to press out extra green stuff and allow it to cure. This leaves some hellish flash but that was easily cut away with a knife and steady hand.
And WarFog was kind enough to post his guide on casting with Procreate which can be found Here @ Warfog's Blog.
What technique did you use?? Looks amazing!
ReplyDeleteI used a two part mold made from insta mold. I had to make the bottom mold first then dorhe top. I also designed my moldhalves to fit in a pair of 25mm bases. Doing that let me press the two halves in a vice to press out extra green stuff and allow it to cure. This leaves some hellish flash but that was easily cut away with a knife and steady hand.
ReplyDeleteHere is my tutorial on this, I started using ProCreate instead of GS for much better results. Not that yours does not look awesome, ProCreate is much harder when cured 60/40 mix as per directions
ReplyDeletehttp://warfrog.blogspot.com/2011/05/saving-ebay-finds-by-casting-your-own.html